Do u think this is a good setup, stock 1600 case with 1641 pistons and juggs stock heads with scat rockers and a webber progressive carb

_________________
if you cant duck it fudge it

If it is built well, it should run for a long time.

_________________
Woodsbuggy forum is now on the Tapatalk Mobile app... (iPhone, iPad and Android devices)

I think u hook. It to a 3 rib and only have 12" wide tires u can do just about anything with it

_________________
i wana ride, i wana ride, i wana ride

If the rockers are 1.25 put high rev springs on the heads & a w100 cam

Well i unfortionatlly have a car tranny with a swing axel can get a 3 rib from my buddy for cheeeeap but then have tp convert it to irs n cant afford new traling arms etc

_________________
if you cant duck it fudge it

And they are 1.25 rockers

_________________
if you cant duck it fudge it

If they are just stock rockers on Scat solid shafts go for a VZ 14 cam. x2 on the 100 with 1.25 rockers. There were stock looking 1.25 rockers. The hole for the pushrod is off set for the 1.25 ratio and centered for the 1.1 ratio. With 1.4 rockers get the FK 65 cam. Use single HD valve springs and retainers.

Hyde I see where your going with that.I built a motor with a Ingle100 it was a torx monster

1641 with a swingaxle was in my first buggy back 20 years ago. I ran the hell out of that buggy and had a blast with it. Run it and have fun!

Roy

_________________
________________________________

Buy the best and cry once.