I have no spindles that these will fit. Looking to sell or trade them for King pin ones.

_________________
[url=http://www.TickerFactory.com/]

[/url]

i would think that all you had to do is swap out the bearings for the kingpin spindle bearings, i dont think the wheels are any different just the bearings

_________________
Just Stand On It!!!!

Chris

Well if anyone knows the conversion bearings that would be great.

_________________
[url=http://www.TickerFactory.com/]

[/url]

if im not mistaken the bearings my buddy ordered for his spindle mounts were 52mm O.D. so maybe if you can check and see what the O.D. is on what you got then you tell that way if the bearings will interchange

_________________
Just Stand On It!!!!

Chris

Inners and outers are different on the balljoint ones.

_________________
[url=http://www.TickerFactory.com/]

[/url]

i knew the inner and outer I.D. of the bearings were different but thought that O.D. was the same on all spindle mount bearings

_________________
Just Stand On It!!!!

Chris

i do think u can find bearings for it,i seen them somewhere in a magazine

The conversion bearings you are looking for are available, However, the reliability factor + the cost = sell them and buy kp wheels. You'll be further ahead. JMO

_________________
Don't sweat the petty stuff, pet the sweaty stuff.

Thanks, that was the original plan. Just need them when I go to the dunes a few times a year.

_________________
[url=http://www.TickerFactory.com/]

[/url]

go to donssport.com. you may need to call them but they have the convertion bearings you need to put ball joint wheels on a king pin spindle.

Called him up this morning. $45 + tax & Shipping. Not bad.

_________________
[url=http://www.TickerFactory.com/]

[/url]