i have a swing axle rear end that i dont like.is there a good kit out there for this conversion or should i toss it for another irs rear end

_________________

They make an irs pivot that welds in for this conversion. Nearly all buggy shops carry them. Along with that the easiest thing to do with your spring plates is to cut them down. You can do this without removing them from the car. Try and get an irs spring plate to trace/line up before you cut and drill. Then youl will need trailing arms, cv's, axles...

_________________
A broken clock is right two times a day.

You might try and get an irs rear end too. You can usually find them with every thing that you need (arms, cvs, axles, trans (if your going to use sedan). Then you will have all the bolts that you need too.

_________________
A broken clock is right two times a day.