does anybody have a good picture of the gear carrier and how that the shift rods and detent ball and springs go together along with one of the spring loaded gear selecter part (the part the hockey stick moves)?

this is a 6 rib nose shift i bought from a buddy about 3 year ago as a basket case and am trying to put it back together now

_________________
Just Stand On It!!!!

Chris

carry that tranny to stacy tylers house,all hes got is 6 ribs,u can look at his

allready thought about that but all of his is together and i need to see how long the detent spring on the shift rods are and what that other pin is for and if a spring or anything goes in there with it and i know he aint gonna want to pull a shift rod out of a good housing anyway.

i just thought maybe somebody had like a cutaway view pic of one on here somewhere?

i checked eric debord's link on the homepage and was gonna look on there but it didnt work anymore

_________________
Just Stand On It!!!!

Chris

Dig through these and see if they help any

http://www.longenterprises.com/diagram_ ... amlist.htm

maybe #15

http://www.ratwell.com/technical/091Tra ... l#nosecone

_________________
If your clutch ain't slippin,, you probably got it adjusted right!!!!!

ive looked at the long enterprise diagrams but it would help if the numbers were given in a chart with a part description but #15 parts 2, 3, 8, 18, and 19 also # 10 parts 61, 62, 67, and 68 are what im needing help

also with the spring loaded setup and brackets in #13 parts 44, 45, 45a, 46, 47, 48, 49, and 50 all the other ones ive had the nose cone off of didnt have this spring loaded setup and i could put it together like those but not sure about where the springs go and that extra short bracket goesand where the little c-clip goes

_________________
Just Stand On It!!!!

Chris