my 6 rib trans keeps popping out of reverse and has a slight grinding noise when it dose so.....


the rest of the gears are fine


any help....??

thanks
tanner

_________________
new to the buggy world so any help would be great

is the shifter adjusted so it goes all the way in ? make shure of this ,take the shifter rod loose to check it if it is in all the way and it still jumps out ,PUT IN A NEW REVERSE GEAR

how hard is it to replace the revrse gear,,,,, could i do it... or not..??

_________________
new to the buggy world so any help would be great

first if you still have rev. no need to replace it. you have a linkage problem. take your shifter lose and slide it as far forward as you can. see if this helps. did you have it before powder coating? is it a stock shifter? let us know

_________________

the guy who was going to powder coat oven broke and wasnt going to be done with it in time for d&k so i had to spray paint it..... for now

and ill try with unhookin the linkage ill let you know

_________________
new to the buggy world so any help would be great

just cause it still works doesnt mean its any good ive have pulled them apart and all the teeth were almost side ways on the little gear and the teeth on the 1 2 slider were half way gone it could be an external shift linkage problem but it could be the linkage inside has moved also

you where right it was the lingage i got it fixed thanks

_________________
new to the buggy world so any help would be great

is the shifter adjusted so it goes all the way in ? make shure of this
ain't this what I said 3 or 4 post ago

you can lead em to water rock, but..........

_________________
2332cc Air Cooled Screaming Meanie. Predator Singleseat.

"Lets go get stupid"

Tanner followed Rock's advice and checked the linkage,,,good job Tanner,,,see you at the Easter Hill Climb

_________________
If your clutch ain't slippin,, you probably got it adjusted right!!!!!