I need to know how far the back wheel should stick out from the tree bar.I know it is a little bit,but just want to make sure it is not to far.I took a straight edge across the back tire and i have 2.5 in. to the tip of the tree bar.Could some of you measure yours and let me know what yours is.I have a Beeline Cobra frame with firestones.

mine are 1.5 in. past my tires

buckmaster we made mine stick out past the tire about a 1/2 inch. just make sure the tire is not exposed at all ask DVS1 about that

_________________
2332cc Air Cooled Screaming Meanie. Predator Singleseat.

"Lets go get stupid"

Mine stick out 1/2 inch past the tire. Don't get them to close to the tire or the tire will rub it when it is in full compression. Tack it on then get 5 of your buddies to bounce it hard to compress the suspension all the way to check for clearance.

_________________
________________________________

Buy the best and cry once.

Mine are about two inches from being as wide as the tires.........
That way when I bought the buggy.
I need to put weld some spurs on and all would be good then..........

_________________
Gary

Turbo VW Sand Racer
Polaris Ranger



"If you don't run into the Devil every once in awhile, you must be going in the same direction!"

Davis Motorsports FaceBook Page

All the info you guys gave me sounds good,i just misunderstood when i was talking to a friend.Thanks for the help.

Thats a bad memory I try to forget.

_________________
When in doubt, hit it in second gear!