It is currently Sun May 03, 2026 11:56 am

Board index » Tech and Fab » Air Cooled Engines

All times are UTC - 5 hours [ DST ]




Post new topic Reply to topic  [ 6 posts ] 
Author Message
PostPosted: Sun Apr 20, 2008 9:04 pm 
Offline
User avatar

Joined: Sun Sep 02, 2007 8:13 pm
Posts: 99
Location: Priceville, Alabama
just had a 1915cc built but its not ideling right and when i take off it hesitates a little what is more likely gonna be my problem any and all help and info is appreciated.

Phillip Peppers

_________________
Phillip


Top
 Profile  
 
 Post subject:
PostPosted: Sun Apr 20, 2008 9:14 pm 
Offline
User avatar

Joined: Thu Dec 06, 2007 10:55 pm
Posts: 292
Location: Charleston WV
Sounds like the carb what kind do you have?

_________________
Travis


Top
 Profile  
 
 Post subject:
PostPosted: Sun Apr 20, 2008 9:18 pm 
Offline
User avatar

Joined: Sun Sep 02, 2007 8:13 pm
Posts: 99
Location: Priceville, Alabama
2brl progressive webber brand new

_________________
Phillip


Top
 Profile  
 
 Post subject:
PostPosted: Sun Apr 20, 2008 9:27 pm 
Offline
WB Videographer
User avatar

Joined: Tue Dec 25, 2007 12:40 pm
Posts: 1617
Location: selmer tn. pickwick tn.
are the chokes still in the carb.?sounds like u could have a vaccum leak somewhere,intake gasket or rubber boots leaking a little


Top
 Profile  
 
 Post subject:
PostPosted: Sun Apr 20, 2008 9:57 pm 
Offline
User avatar

Joined: Thu Dec 06, 2007 10:55 pm
Posts: 292
Location: Charleston WV
You mite have a intake gasket or boot leaking, or a idle jet plugged. Most every progressive iv worked on the pim. and sec. jet was to small dont know what size to use I jest use a torch tip dill set and open them up if you go to big you can solider it closed and start over. Or buy bigger jets. Also the smaller air bleed the richer it will be. Not for sure this is your prob. but it sounds like it.

_________________
Travis


Top
 Profile  
 
 Post subject:
PostPosted: Mon Apr 21, 2008 7:14 am 
Offline

Joined: Sun May 20, 2007 9:25 pm
Posts: 251
If it is a new intake, most are too long and bottom out in the end castings and will not allow them to seat on the heads properly. Remove any mounting bolts and see if you can move the intake sideways in the castings. If not, then usually about and 1/8 to 1/4 cut off of each end is fine.

_________________
In GOD we trust.....ALL others pay cash.


Top
 Profile  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 6 posts ] 

Board index » Tech and Fab » Air Cooled Engines

All times are UTC - 5 hours [ DST ]


Who is online

Users browsing this forum: No registered users and 1 guest


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Search for:
Jump to:  
Powered by phpBB® Forum Software © phpBB Group