Wondering what u guys run for throttle cable and how.......

i use a throttle cable just kiddin! you can use any thin cable and rig it up somehow, personally mine runs thru a piece of 3/8 copper tube from by the peddle to back before the shroud then hooks up to a cb performance diffent kinda ,to hard to explain but you should run it thru the shroud to keep the cable from being worn or gettin frayed. and i use copper cause it doesnt rust like brake lines do which is another way of running it to the back! hope this helps

_________________
ANTI- antifreeze!!!!!!

morse cable is a clean option buy it cut it to length and install with clamps along the center pipe of buggy floor. alittle costly but real effective and clean looking.

I'm using 3/8 hyd hard line lined with ice maker line in side so the cable will not rust and hang up. Been running it that way for 3 years with no problems.

_________________
My ECOTEC swap http://www.woodsbuggy.com/index.php?option=com_jfusion&Itemid=10&jfile=viewtopic.php&f=23&t=11394

Morse cables are nice and clean,but you can get some small plastic tubing run some small cable through it,or copper tbg. You can get the little boots off a ten speed cable and put on the ends to keep mud and water out.Chad

_________________
NOW GAS IT!!!!!

Morse cable hands down is better.
With other setups, when you get water and mud in the tube with your cable, it can freeze on a cold morning, leaving you with no throttle.
We've had that happen more than once.

_________________
A good friend will bail you out of jail. A best friend will be sitting next to you saying: "Damn that was fun!"



http://www.youtube.com/watch?v=A5wGMaUMXUQ

the first thing on this link and the cable that my local buggy shop has

http://www.dansperformanceparts.com/bug ... ytcbh3.htm

_________________


I DO NOT FREE BASE COCAINE

I was running a Morse cable $$$ only problem was they are next to impossible to lubricate. After time they will stiffen up without lube. On my current project I will use plastic tubing with stainless cable. That way I can force oil through it to keep it lubed and since mine has a fiberglass body, water getting in shouldn't be a big issue.

_________________
Of all the things I've lost, I miss my mind the most.
M
A
G
A

Mine is 10 yrs old,and no problems yet.
I've never lubed it, but it does have rubber seals on each end.

_________________
A good friend will bail you out of jail. A best friend will be sitting next to you saying: "Damn that was fun!"



http://www.youtube.com/watch?v=A5wGMaUMXUQ

I work at a truck fleet shop so mine is a stainless trailer roll door cable run thru air brake tubing . Already has a eyelet for the pedal end and cut it into with a welder at the carb end so it wont unravel