In need of a 3 rib bell housing, any Ohioans nearby

anybody???

I will have a broken 3 rib at the lansing buggy show. 150.00 for the whole thing. It binds when you put it in gear, never took it apart could be something easy or difficult to fix. Thanks Dave T

_________________
RAJAY + SAND = FUN!!! Can we put a turbo on that??*** Hey look in here for more junk.*** http://s119.photobucket.com/albums/o157 ... ndoffroad/

hows the condition of the bellhousing? Would you be willing to sell just that?

Bell housing is fine. I will sell just the bell after the Lansing show if the whole trans does not sell. Thanks Dave T

_________________
RAJAY + SAND = FUN!!! Can we put a turbo on that??*** Hey look in here for more junk.*** http://s119.photobucket.com/albums/o157 ... ndoffroad/

ok, let me know.

I have one without the mounting ears on the top if your interested.Give me a call and we can work out the details.513-594-2879 anytime after 6p.m.

i really need one i can bolt on and use..thanks though

Nick are you using the transmission straps as mounts? If so those top mounting ears won't matter. Most buggys run the straps and do not make use of those mounting ears on the top.

_________________
Bite off more than you can chew, then chew like hell.

glad you said something kyle, i was thinking of the motor mount ears. i need to snag this

damn 3.5hrs

just go up to la products. pats got them for 85 a piece with a core. or just buy a front shift 6 rib housing. shes got them sitting on the shelf and but a 6 rib starter. its alot closer than 3.5 hours away.

i ve got one without ears im connellsville pa 15425 if this helps let me know

Thanks buggie junky but your not much closer. If i dont end up getting the one from aaron, you will hear from me. Wasn't looking to spend that much but worst case ill hit up LA.

if you want a 6 rib one i have one i think. i forget what you have to do to make a normal starter work, i think you just mill off the mounting plate surface of the bellhousing.

Jeff, do you know anybody that can do that?

Eric DeBord,,,MadMike

_________________
If your clutch ain't slippin,, you probably got it adjusted right!!!!!

or any local machine shop

_________________
lets just ride

I really just want to get a 3rib one, but if i go with the 6rib housing do you know the specs on how much i need to shave off of it? Would it be easier and/or possible to mill the plate on the starter instead?

I dont remember exact but its not much.. Measure form the mounting base of starter to end of bellhousing and that will tell you.

I think it is about 1/4 inch , , the 6 rib bell has a beefier thro out bearing arm. If you are set on a 3 rib bell, and can't find one cheaper,,, I have one I will sell for $45 shipped.

_________________
If your clutch ain't slippin,, you probably got it adjusted right!!!!!

I think a 3 rib bell is my best bet, I just considered the 6 because jeff is so close to me and im anxious to get one soon. Firebug think you can get some close up pics to me sometime tomorrow? is it ready for me to pop on and use? thanks for the help!

sure,,I was saving it for a spare build but I don't seem to be getting it done

_________________
If your clutch ain't slippin,, you probably got it adjusted right!!!!!