I switched over to 3x5 arms from beeline and torsion eliminators. The eliminator plates are from empi the hiems are from speedway an the double sheer from drews. My problem is the front of my tire are an inch angled out from the back. I've adjusted the hiem nut as much as I can an I've taking the two washer on the front of the arm an put on the outside instead of inside against the torsion. Am I missing something? Is there another way to adjust? Here's a couple pics but its a little hard to see whats going on.

_________________
What do you mean your in limp mode?

I had this priblem when i put madmikes torsion eliminators on. I took 1/2" off the threaded part of eliminTor so i coukd screw it in farther .

_________________
"IT IS WHAT IT IS"

That's what I thought about doing makin in flush with the plate. Thanks for the reply!

_________________
What do you mean your in limp mode?