Joined: Tue Apr 21, 2009 9:56 pm Posts: 124 Location: Clarksville, TN
|
I know I've seen this somewhere but can't seem to find it. . . So here goes.. Trying to figure out the best way to reset my torsion for max ride height without being too terribly stiff in the back. This will be the third time I've had to reset it. The previous two times I set the spring plates at a 25 degree angle to the buggy and started out ok, but as it settled became lower than what I want. I am running 3x3 arms with 930 cv joints, so how far can I crank the angle on the spring plate safely? Tired of bottoming out.. lol.... And is that the proper way of adjusting it, with the buggy level then measuring the angle of the spring plates?
|
|