WoodsBuggy.com https://www.woodsbuggy.com/phpBB3/ |
|
Compression ratio for w110 https://www.woodsbuggy.com/phpBB3/viewtopic.php?f=3&t=17776 |
Page 1 of 1 |
Author: | CSEbug [ Wed May 06, 2015 9:23 pm ] |
Post subject: | Compression ratio for w110 |
Hey guys I'm getting ready to order my heads and want to figure out the compression so I can have them flycut if needed. Running an engle w110. My deck height is .055" . I plan on going with 044s from CB which have a 55cc chamber. This would put me right at about 8:1. Should I aim for higher? Must stay on pump gas. Looking for a good balance of power without sacrificing too much longevity/reliability. My setup: 1835 CB 044s 40x45 Engle w110 44idf or 40idf single. |
Author: | RaceBugg1098 [ Thu May 07, 2015 8:04 am ] |
Post subject: | Re: Compression ratio for w110 |
pump gas and power don't belong in the same sentence when talking about air cooled. I would shoot for AT LEAST 8.5:1 if not 9:1. Personally I would go 12.5:1 and buy race fuel. |
Author: | jimp [ Thu May 07, 2015 9:06 am ] |
Post subject: | Re: Compression ratio for w110 |
http://vwparts.aircooled.net/Engle-W110 ... /e6110.htm |
Author: | Roy [ Thu May 14, 2015 9:15 pm ] |
Post subject: | Re: Compression ratio for w110 |
I would use 9-1 if I was building it. Still ok using 93 octane with this combo as long as the timing stays reasonable. DOn't over advance and it will last a long time. |
Page 1 of 1 | All times are UTC - 5 hours [ DST ] |
Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |