WoodsBuggy.com https://www.woodsbuggy.com/phpBB3/ |
|
Need ideas https://www.woodsbuggy.com/phpBB3/viewtopic.php?f=3&t=16130 |
Page 1 of 1 |
Author: | Ripinitup [ Wed Oct 09, 2013 4:09 am ] |
Post subject: | Need ideas |
I want to run oil pressure gauge and light. Also want to run oil temp gauge. My problem is...... where the sender for the light is I currently have a mechanical oil pressure gauge and the oil line for my turbo bearing. The turbo bearing feed works very well from that spot so I would like to leave it there. Where can I put the senders for everything else? |
Author: | hillaholic [ Wed Oct 09, 2013 9:50 am ] |
Post subject: | Re: Need ideas |
Do you have a remote filter? There should be a spot on top of it to drill and tap. Posted using the WoodsBuggy Mobile App |
Author: | jrvb [ Wed Oct 09, 2013 9:52 am ] |
Post subject: | Re: Need ideas |
hillaholic wrote: Do you have a remote filter? There should be a spot on top of it to drill and tap. Posted using the WoodsBuggy Mobile App X2 ![]() |
Author: | hillaholic [ Wed Oct 09, 2013 9:54 am ] |
Post subject: | Re: Need ideas |
Like this. ![]() Posted using the WoodsBuggy Mobile App |
Author: | Ripinitup [ Wed Oct 09, 2013 3:21 pm ] |
Post subject: | Re: Need ideas |
That would be for the oil pressure or temp? Posted using the WoodsBuggy Mobile App |
Author: | hillaholic [ Wed Oct 09, 2013 3:48 pm ] | |||
Post subject: | Re: Need ideas | |||
Ripinitup wrote: That would be for the oil pressure or temp? I have a T at the block. Make sure you get the correct metric pipe thread. Sorry I forget the size. Then run pressure and light there. Then you could put the temp on the oil filter. Or if you have a type 3 case you can put the temp where the type 3 dipstick goes. They make an adaptor for it. Think it's like $12.00.
|
Author: | Ripinitup [ Wed Oct 09, 2013 4:06 pm ] |
Post subject: | Re: Need ideas |
Cool thanks. |
Author: | Ripinitup [ Wed Oct 09, 2013 5:08 pm ] |
Post subject: | Re: Need ideas |
Anyone ever use the digital gauges? Dragon gauges is the name I think Posted using the WoodsBuggy Mobile App |
Author: | gasman [ Wed Oct 09, 2013 8:24 pm ] |
Post subject: | Re: Need ideas |
They make a sandwich plate that You screw on between your filter that you can plumb off of. Chad ![]() |
Author: | Ripinitup [ Thu Oct 10, 2013 7:00 am ] |
Post subject: | Re: Need ideas |
Is there any other place besides where the factory sender goes to put a oil pressure sender? Posted using the WoodsBuggy Mobile App |
Page 1 of 1 | All times are UTC - 5 hours [ DST ] |
Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |