| WoodsBuggy.com http://www.woodsbuggy.com/phpBB3/ |
|
| Engine block flycut to accept 92mm jugs http://www.woodsbuggy.com/phpBB3/viewtopic.php?f=7&t=5041 |
Page 1 of 1 |
| Author: | scotty [ Sat Nov 08, 2008 10:14 am ] |
| Post subject: | Engine block flycut to accept 92mm jugs |
I gotten this on a trade, it has been setting for awhile. The guy had it machined to accept 92mm jug's, not sure but I think that will make a 1914cc. It is an AS41. I also have one other stock block that I have the case split. And 6-8 other almost complete engines for sale. A really strong 1915 with a 44mm weber. Tons and Tons of other parts. Too many to list. I will make someone a Graet deal on everything I have, I have 4 Rails and planning on getting down to just one. Most my parts are OEM with exception of a few aftermarket. Seymour,IN 47274 812 524 0621 812 767 2100 |
|
| Author: | Baddvw [ Sat Nov 08, 2008 11:35 am ] |
| Post subject: | Re: Engine block flycut to accept 92mm jugs |
scotty wrote: I gotten this on a trade, it has been setting for awhile. The guy had it machined to accept 92mm jug's, not sure but I think that will make a 1914cc. It is an AS41. I also have one other stock block that I have the case split. And 6-8 other almost complete engines for sale. A really strong 1915 with a 44mm weber. Tons and Tons of other parts. Too many to list. I will make someone a Graet deal on everything I have, I have 4 Rails and planning on getting down to just one. Most my parts are OEM with exception of a few aftermarket. Seymour,IN 47274 812 524 0621 812 767 2100 If the engine has a stock stroke (69mm) and 92mm jugs then it will be an 1835cc, I had one before and it runs very good with a single weber 40. |
|
| Author: | scotty [ Sat Nov 08, 2008 1:25 pm ] |
| Post subject: | Re: Engine block flycut to accept 92mm jugs |
I forgot to put a price. I'll take $175.00 for both of them. I'm looking for a DCOE40 carb. |
|
| Author: | sv1332 [ Sat Nov 08, 2008 11:21 pm ] |
| Post subject: | Re: Engine block flycut to accept 92mm jugs |
both of what? the case and 1915 with the 44 weber? |
|
| Author: | scotty [ Sun Nov 09, 2008 9:13 pm ] |
| Post subject: | Re: Engine block flycut to accept 92mm jugs |
Both cases, the carb on the complete engine is worth more tham $175 |
|
| Author: | sv1332 [ Sun Nov 09, 2008 9:19 pm ] |
| Post subject: | Re: Engine block flycut to accept 92mm jugs |
i figured, just checkin |
|
| Page 1 of 1 | All times are UTC - 5 hours [ DST ] |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|