WoodsBuggy.com
http://www.woodsbuggy.com/phpBB3/

Scat/Autocraft 2724 dry sump Race engine
http://www.woodsbuggy.com/phpBB3/viewtopic.php?f=7&t=4325		 Page 1 of 1
Author:  Robb Vaughan [ Fri Jul 25, 2008 12:50 pm ]
Post subject:  Scat/Autocraft 2724 dry sump Race engine
Fresh rebuilt 2724 (84x101.6). Scat dry sump case with 6 studs per cylinder. Autocraft 910 heads with spray bars and new stnls. stl. valves 50mm/38mm, new guides, and new seats. The heads also have the original unmolested ports. Scat crank, Carrillo rods, JE pistons, 1.4 and 1.25 needle bearing rockers with new bearings. New Autocraft 2 stage oil pump, and new cylinders. 48 I.D.F. Webers with new linkage. billet air cleaners. New Autocraft cam and lifters Part # SCO. Comes complete with Porshe fan/alt and fiberglass shroud, custom made 1-3/4 inch tube merged header and Flowmaster muffler. Also includes the C.B. oil tank and all oil lines and a Scat oil fiter mount with adjustable oil pressure, and a Kennedy stage 3 clutch assy.. Ignition is .009 with pertronix module and MSD wires. This was built for a Class 5 Unlimted Baja desert race car. I sold the car and no longer need this engine. Located in Az. I've been asking 9500 complete or 7500 for the long block, which is far less than invested. I'm open to offers or trade, part trades. Id rather trade for something I can use than totally lose my a$$. Email or call is ok. rvaughan7@cox.net or ph. 602 722 2982
Author:  nickschlemer [ Sat Jul 26, 2008 3:18 am ]
Post subject:  Re: Scat/Autocraft 2724 dry sump Race engine
Robb Vaughan wrote:
Fresh rebuilt 2724 (84x101.6). Scat dry sump case with 6 studs per cylinder. Autocraft 910 heads with spray bars and new stnls. stl. valves 50mm/38mm, new guides, and new seats. Scat crank, Carrillo rods, JE pistons, 1.4 and 1.25 needle bearing rokers with new bearings. New Autocraft 2 stage oil pump, and new cylinders. 48 I.D.F. Webers with new linkage. billit air cleaners. New Autocraft cam and lifters Part # SCO. Comes complete with Porshe fan/alt and fiberglass shroud, custom made 1-3/4 inch tube merged header and Flowmaster muffler. Also includes the C.B. oil tank and all oil lines and a Scat oil fiter mount with adjustable oil pressure, and a Kennedy stage 3 clutch assy.. Ignition is .009 with pertronix module and MSD wires. This was built for a Class 5 Unlimted Baja desert race car. I sold the car and no longer need this engine. Located in Az. I've been asking 9500 complete or 7500 for the long block, which is far less than invested. I'm open to offers or trade, part trades. Id rather trade for something I can use than totally lose my a$$. Email or call is ok. rvaughan7@cox.net or ph. 602 722 2982



Lets see some pics of this badboy..
Author:  Robb Vaughan [ Sat Jul 26, 2008 10:34 am ]
Post subject:  Re: Scat/Autocraft 2724 dry sump Race engine
I can't get my pics to post here on this site, they work everywhere else. I will try again. You can see it on thesamba.com or you can email me and I'll send some over.
Author:  Bad Influence [ Sat Jul 26, 2008 3:33 pm ]
Post subject:  Re: Scat/Autocraft 2724 dry sump Race engine
If you want to email em to me I will post em up for ya. Just pm me.
Author:  hillaholic [ Sat Jul 26, 2008 4:00 pm ]
Post subject:  Re: Scat/Autocraft 2724 dry sump Race engine
Here ya go

Image
Image
Image
Image
Image
Image
Author:  Robb Vaughan [ Sun Jul 27, 2008 10:32 am ]
Post subject:  Re: Scat/Autocraft 2724 dry sump Race engine
Thanks, Bad Influence for offering to post and thanks Hillaholic for posting the pics. I'm not real sharp with the computer.
Author:  sawyer [ Sun Jul 27, 2008 8:20 pm ]
Post subject:  Re: Scat/Autocraft 2724 dry sump Race engine
What kind of hp does that moutain motor put that would look rite a home on my woods buggy
Author:  kybuggy1 [ Sun Jul 27, 2008 8:51 pm ]
Post subject:  Re: Scat/Autocraft 2724 dry sump Race engine
PM sent
Author:  Robb Vaughan [ Mon Jul 28, 2008 10:37 am ]
Post subject:  Re: Scat/Autocraft 2724 dry sump Race engine
sawyer wrote:
What kind of hp does that moutain motor put that would look rite a home on my woods buggy

If I remember correctly I think the conservetive estimate was 215- 225.
Author:  Robb Vaughan [ Fri Aug 01, 2008 12:36 pm ]
Post subject:  Re: Scat/Autocraft 2724 dry sump Race engine
Robb Vaughan wrote:
sawyer wrote:
What kind of hp does that moutain motor put that would look rite a home on my woods buggy

If I remember correctly I think the conservetive estimate was 215- 225.

So Sawyer, is this insufficient hp? You could turbo it. And with 6 studs per cylinder it will handle it very well. As I originally stated I'm open to offers as I'm sure if somone on this site was to purchase it there will most likley be shipping costs involved.
Author:  Robb Vaughan [ Thu Sep 25, 2008 9:23 pm ]
Post subject:  Re: Scat/Autocraft 2724 dry sump Race engine
Well I still have it and it needs to go. 8000 OBO or 7500 OBO for the longblock.
Page 1 of 1 All times are UTC - 5 hours [ DST ]
Powered by phpBB® Forum Software © phpBB Group
https://www.phpbb.com/