x2 wish you posted this before i built my motor
| WoodsBuggy.com http://www.woodsbuggy.com/phpBB3/ |
|
| 1915 3 rib and vw parts http://www.woodsbuggy.com/phpBB3/viewtopic.php?f=7&t=15545 |
Page 1 of 1 |
| Author: | volksdude2007 [ Tue Jun 11, 2013 3:44 pm ] |
| Post subject: | 1915 3 rib and vw parts |
im looking to sell all this as a package deal I don't want to sell separately sorry. I will still be running my buggy when I can and as you guys know ya need both to do so. its a long post so ill put the price up here wanting $2000 for everything I have listed I am going to install a 6 rib and 2.2 Subaru again this winter and figured id get a jump on trying to sell it thanks motor: 1915cc dual weber 44 carbs (made in spain) empi linkage bosch 009 distributor electronic ignition new plugs new wires 8 dowell pin stock crank new 40x35.5 heads single valve springs newer 94mm jug and piston kit lightened flywheel new clutch stock pressure plate I want to say engle 110 cam if not then a vz15 cam sorry cant remember which he said newer 1 wire alternator newer stock fuel pump power pulley for anyone curious aluminum dog house bolt on valve covers stock rockers spring loaded plastic pushtubes may be something else I am missing motor runs good 3 rib trans is in good shape slides right into each gear nice, reverse works good also the other parts I have: 2 blocks 2 empi 40 carb bodies no tops 1 weber 44 carb and intake froze up may be good core for something 1 set of empi dual intakes 1 set of unknown dual carb intakes looks like someone started porting them out scat lifters and rockers some still in package may still be good spare distributors 009 and vaccumm advanced 4 complete car axles cv to cv and also other car cvs have 12-15 car cv I do believe new scat c-95 cam miscellaneous gaskets and seals and lots of other small parts oil pumps, heads set of eepco big valve heads cut for 94s they are cracked down by push tube hole but may be salvageable still never had them on a motor new 88mm high compression mahle piston cyclinder kit used mahle 94mm piston jug kit there is a 90 or 92mm piston jug kit also in those parts I believe oil cooler and remote oil filter will be left on motor when removed |
|
| Author: | volksdude2007 [ Tue Jun 11, 2013 10:01 pm ] |
| Post subject: | Re: 1915 3 rib and vw parts |
Just throwing this out here do you guys think this is a fair price for everything or am I asking too much for it the case has very little end play and forgot to mention its an as-41 case which from what I read online its just a replacement case from what I was getting any input? Thanks |
|
| Author: | Ripinitup [ Wed Jun 12, 2013 4:18 pm ] |
| Post subject: | Re: 1915 3 rib and vw parts |
2k sounds about rite. Wish I had the cash. I would come get it today lol |
|
| Author: | hpfreak [ Wed Jun 12, 2013 7:52 pm ] |
| Post subject: | Re: 1915 3 rib and vw parts |
x2 wish you posted this before i built my motor
|
|
| Page 1 of 1 | All times are UTC - 5 hours [ DST ] |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|