Roy, the PO told me they were stock or 5.4. No brand name on them however they look just like CB Performance. Probably made by the same company. lol.
| WoodsBuggy.com http://www.woodsbuggy.com/phpBB3/ |
|
| 94 MM cylinders and "H" beam rods http://www.woodsbuggy.com/phpBB3/viewtopic.php?f=7&t=10702 |
Page 1 of 1 |
| Author: | Odyknuck [ Wed Nov 17, 2010 5:20 pm ] |
| Post subject: | 94 MM cylinders and "H" beam rods |
I have 2 brand new Cima Malhle stroker cylinders for 100 Bucks shipped And a brand new set of Chromoly "H" beam rods with VW jornels for 150 Bucks shipped. |
|
| Author: | Roy [ Wed Nov 17, 2010 7:18 pm ] |
| Post subject: | Re: 94 MM cylinders and "H" beam rods |
What length are the connecting rods? What brand are they? Thank you. |
|
| Author: | Odyknuck [ Thu Nov 18, 2010 11:11 am ] |
| Post subject: | Re: 94 MM cylinders and "H" beam rods |
Roy, the PO told me they were stock or 5.4. No brand name on them however they look just like CB Performance. Probably made by the same company. lol.
|
|
| Author: | turboblue [ Thu Nov 18, 2010 12:35 pm ] |
| Post subject: | Re: 94 MM cylinders and "H" beam rods |
If it helps any, those cylinders are the same length as a non-stroker cylinder. Wrist pin location in the piston is the difference. |
|
| Author: | Odyknuck [ Thu Nov 18, 2010 1:52 pm ] |
| Post subject: | Re: 94 MM cylinders and "H" beam rods |
Thanks for the additional info. I probably should of added they could be also used with "A" pistons. Spare cylinders have come in handy a few times for me. You don't always need to replace all 4. As an example I had a risk pin clip fall out and score the cylinder and the other 3 cylinders were fine. |
|
| Page 1 of 1 | All times are UTC - 5 hours [ DST ] |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|