Finished off some last bits of dashboard wiring today (few extra's been added, launch control settings, etc), and tidied all the wiring behind it into neat runs, switched idiot lights out for LED's (which then required ripping them to bits and trying to add diodes and ballast resistors in the case of the alternator charging light....good fun trying to solder them in a space about 8mm x 4mm.....lots of swearing, some burnt fingers.
Anyway, kettle went on, coffee came out, shiny lights:
As promised, new front bonnet, ignore the steel box section, it was just there to hold the front square whilst welding as it's fairly thin aluminium, it's on hinges now and will get a gas ram lifter fitted to secure it, much easier to work on if you break down away from the service area then.
And new floorpan is on, new bulkhead, seat mounts, pedals, etc:
). 
