Both washers go on the outside of the arm between the bolt head and arm.
This one only has had only one washer for the last three years as I only had a spare pivot bolt but no spare washer out on the trail when one fell out..
Hope this helps.
| WoodsBuggy.com http://www.woodsbuggy.com/phpBB3/ |
|
| need help on rear arms http://www.woodsbuggy.com/phpBB3/viewtopic.php?f=4&t=9541 |
Page 1 of 1 |
| Author: | dirtdobber [ Sun May 23, 2010 9:21 pm ] |
| Post subject: | need help on rear arms |
Put new arms on buggy,I put 1 washer on outside part of arm. I did not on trans side of arm. what did i do wrong ? arm is binding, bolt is almost threw flange. Can somebody help? |
|
| Author: | Stevo [ Sun May 23, 2010 9:32 pm ] |
| Post subject: | Re: need help on rear arms |
You should have 2 washers on the outside of the arm. Make sure you have the metal tube in the rubber bushing too. |
|
| Author: | A. Cole [ Sun May 23, 2010 9:34 pm ] |
| Post subject: | Re: need help on rear arms |
I can't remember if it is 1 or 2 washers against the pivot bolt head,but I know they go on the outside. |
|
| Author: | A. Cole [ Sun May 23, 2010 9:34 pm ] |
| Post subject: | Re: need help on rear arms |
suby steve beat me, but thats right. |
|
| Author: | perrib [ Sun May 23, 2010 9:39 pm ] |
| Post subject: | Re: need help on rear arms |
Both washers go on the outside of the arm between the bolt head and arm. This one only has had only one washer for the last three years as I only had a spare pivot bolt but no spare washer out on the trail when one fell out.. Hope this helps. |
|
| Author: | dirtdobber [ Sun May 23, 2010 11:10 pm ] |
| Post subject: | Re: need help on rear arms |
Thanks everyone ,stumped me alittle when didnt match. Putting together in morning. Post pics soon... |
|
| Page 1 of 1 | All times are UTC - 5 hours [ DST ] |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|