Cheers, so much for that idea then
| WoodsBuggy.com http://www.woodsbuggy.com/phpBB3/ |
|
| Torsion bars - end plates fit either end? http://www.woodsbuggy.com/phpBB3/viewtopic.php?f=4&t=9379 |
Page 1 of 1 |
| Author: | PhillipM [ Wed Apr 28, 2010 7:52 am ] |
| Post subject: | Torsion bars - end plates fit either end? |
May sounds a silly question but I've always put the bars back in the same way and never really took much notice - but will a spring plate fit on either end of a rear torsion bar or are they handed with a different spline on the inner? Thinking about using one to make and anti-roll bar with a spring plate on either end. |
|
| Author: | kybuggy1 [ Wed Apr 28, 2010 8:15 am ] |
| Post subject: | Re: Torsion bars - end plates fit either end? |
Different number of splines on each end of bar. |
|
| Author: | PhillipM [ Wed Apr 28, 2010 8:16 am ] |
| Post subject: | Re: Torsion bars - end plates fit either end? |
Cheers, so much for that idea then
|
|
| Author: | Firebug [ Wed Apr 28, 2010 9:39 am ] |
| Post subject: | Re: Torsion bars - end plates fit either end? |
It's still a good idea,,,you could remove the splined section from a torsion tube and graft (weld) it into a spring plate. I have done similar by using a hole saw to remove the splined section from spring plates to graft into the short spring plates when using large tires. |
|
| Author: | MadMike [ Wed Apr 28, 2010 8:00 pm ] |
| Post subject: | Re: Torsion bars - end plates fit either end? |
You can buy the center spline section, can't remember where right now. |
|
| Page 1 of 1 | All times are UTC - 5 hours [ DST ] |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|