| WoodsBuggy.com http://www.woodsbuggy.com/phpBB3/ |
|
| 2 questions http://www.woodsbuggy.com/phpBB3/viewtopic.php?f=4&t=8904 |
Page 1 of 1 |
| Author: | aboone993 [ Tue Mar 02, 2010 10:06 pm ] |
| Post subject: | 2 questions |
I put some s.a.w. 28mm bars in my buggy set it up by the instructions for "stock ride hight " and it was too soft moved it 1 more notch and it seemed perfect but when I adjusted my limit straps up which preloaded the bars some more it rides like a dead axle so my question is how long will it take to relax some ? Question 2 I cut my stops off and added type 4 jointson my stock bus axle but I have been told that I need to remove the bottom c clip off my axle so it can " Float " in the cv Is this right ? |
|
| Author: | JeffClay [ Tue Mar 02, 2010 10:28 pm ] |
| Post subject: | Re: 2 questions |
can't answer you on the torsion bars, but i can tell you that i have ran my joints with no bottom clips, only top clips, for as long as i can remember without any problems. Really they are captivated, they can't go anwhere, and if they did, you'd have a lot bigger problems... |
|
| Page 1 of 1 | All times are UTC - 5 hours [ DST ] |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|