Are these the same?

_________________
Water cooled Dry Sumped Subaru Powered Turbo Charged Fuel Injected 2500CC Tank. Oh Rah! He who dies with the most Toys not only wins, He also wears them out!

[quote='Odyknuck']Are these the same?[/quote]

Both threaded ends should be 11/16"-18.
I hear the newer Ford versions are 3/4"-16.
Tapers are different though.....Ford, I think, is bigger than the IH.

_________________
Gary

Turbo VW Sand Racer
Polaris Ranger



"If you don't run into the Devil every once in awhile, you must be going in the same direction!"

Davis Motorsports FaceBook Page

International are Bigger, with stock spindles, without the gusseted wrap around you don't want to drill/taper the stock tie rod end hole too much without weakening it too much. Most of the steering racks run International ends on the inside, and the ford on the outer.

_________________
A broken clock is right two times a day.

FWIW the # for the International rod end is ES262R (or L). Took me a while to find it. They fit the rack . I needed rod ends on the outside to fit my bus steering knuckle . I found these on ebay and they fit my bus taper on the outside. Item number: 270021654168. firebug. see yall labor day in Alabama