| WoodsBuggy.com http://www.woodsbuggy.com/phpBB3/ |
|
| Angle finder? http://www.woodsbuggy.com/phpBB3/viewtopic.php?f=4&t=7391 |
Page 1 of 1 |
| Author: | nitro_mudder [ Tue Aug 11, 2009 7:18 pm ] |
| Post subject: | Angle finder? |
Anyone got a decent add on angle measuring device for a tube bender? Also I know some of you use programs for laying out bends, whats good whats not? |
|
| Author: | afterburnt [ Tue Aug 11, 2009 7:36 pm ] |
| Post subject: | Re: Angle finder? |
i just use one of those cheap magnetic angle finders that you buy from sears, and just stick it to the pipe as you bend it. I have the degrees machined onto one of my bending die, and I used a piece of wire as a pointer, sometimes thats a pain in the butt, but you can buy little plastic degree wheels or even, i think they have a degree stick tape at McMaster Carr, that you can stick to your die and use a pointer. dave |
|
| Page 1 of 1 | All times are UTC - 5 hours [ DST ] |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|