| WoodsBuggy.com http://www.woodsbuggy.com/phpBB3/ |
|
| question for firebug http://www.woodsbuggy.com/phpBB3/viewtopic.php?f=4&t=6409 |
Page 1 of 1 |
| Author: | Andrew_Ha [ Thu Apr 23, 2009 6:38 pm ] |
| Post subject: | question for firebug |
fire bug i was talking to u in the chat room the other day about the front tranny mount u told me to tilt it. my question is how much and which way. this is probably a dumb question but i just dont want to screw it up |
|
| Author: | MadMike [ Thu Apr 23, 2009 8:21 pm ] |
| Post subject: | Re: question for firebug |
What are you trying to do? |
|
| Author: | Andrew_Ha [ Thu Apr 23, 2009 8:25 pm ] |
| Post subject: | Re: question for firebug |
replace the stock torsion tranny mount with an aftermarket 1the tranny is a 6 rib with a 1915 eng. |
|
| Author: | MadMike [ Thu Apr 23, 2009 8:27 pm ] |
| Post subject: | Re: question for firebug |
Are you having ground clearence problems or something? |
|
| Author: | Andrew_Ha [ Thu Apr 23, 2009 8:31 pm ] |
| Post subject: | Re: question for firebug |
no i was just asking because he tod me to tilt it also wondered if i did how will i get my rear tranny mount to line up |
|
| Author: | Firebug [ Thu Apr 23, 2009 8:36 pm ] |
| Post subject: | Re: question for firebug |
Yea,,I suggested tilting the tranny,,,It will raise the engine a little for more ground clearance and with a bus tranny it will lower the shifter box a little too. If you are redoing the tranny mount anyway it is a good time to make this little modification. I did mine when I went to a 6 rib and kept the tranny forward a little so I could keep the engine from being further back,,,,since mine is WC and a little heavier already. |
|
| Author: | Firebug [ Thu Apr 23, 2009 8:38 pm ] |
| Post subject: | Re: question for firebug |
Andrew_Ha wrote: no i was just asking because he tod me to tilt it also wondered if i did how will i get my rear tranny mount to line up I had to add some mounting bosses above the old rear mounts,,it is simple to do,,just remember to keep the axle flanges in pretty much the same location,,,kinda see-saw at the point of the flanges 
|
|
| Author: | Andrew_Ha [ Thu Apr 23, 2009 8:41 pm ] |
| Post subject: | Re: question for firebug |
thanks for the info |
|
| Page 1 of 1 | All times are UTC - 5 hours [ DST ] |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|