| WoodsBuggy.com http://www.woodsbuggy.com/phpBB3/ |
|
| FRAME ? http://www.woodsbuggy.com/phpBB3/viewtopic.php?f=4&t=5292 |
Page 1 of 1 |
| Author: | 951le [ Wed Dec 10, 2008 11:46 pm ] |
| Post subject: | FRAME ? |
Does anyone know how to tell what if a frame is set up for a KP or BJ front end?It is a brand new frame that is not put together. Thanks |
|
| Author: | khaney01 [ Wed Dec 10, 2008 11:51 pm ] |
| Post subject: | Re: FRAME ? |
mock up the side rails on the floor as they should be welded together then measure between the mounts. BJ is wider than a kingpin. |
|
| Author: | buggymaster [ Wed Dec 10, 2008 11:58 pm ] |
| Post subject: | Re: FRAME ? |
the front clamps are higher on a bj the kingpin is closer and more narrower |
|
| Author: | MadMike [ Thu Dec 11, 2008 7:56 am ] |
| Post subject: | Re: FRAME ? |
When you mock it up, the ball joint frame will measure, from upper clamp center to lower clamp center of about 5 7/8" Link/pin would be about 5 1/4" |
|
| Author: | 951le [ Fri Dec 12, 2008 1:39 am ] |
| Post subject: | Re: FRAME ? |
Thanks for the quick responses |
|
| Page 1 of 1 | All times are UTC - 5 hours [ DST ] |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|