| WoodsBuggy.com http://www.woodsbuggy.com/phpBB3/ |
|
| U-Joints for steering shaft? http://www.woodsbuggy.com/phpBB3/viewtopic.php?f=4&t=3647 |
Page 1 of 1 |
| Author: | Bad Influence [ Fri Apr 18, 2008 8:06 am ] |
| Post subject: | U-Joints for steering shaft? |
Where do you all get em and what size are they. I have a standard size shaft and am at work so i can't measure but wanting to pick up a u-joint and a couple of bearing blocks on the way home. Thanks |
|
| Author: | Odyknuck [ Fri Apr 18, 2008 8:20 am ] |
| Post subject: | |
most buggy shops carry the standard 5/8" (i will assume thats what you have). Race shops like Summit carry them. Automotive parts houses and tractor supply, farm and fleet may. |
|
| Author: | Bad Influence [ Fri Apr 18, 2008 8:33 am ] |
| Post subject: | |
Odyknuck wrote: most buggy shops carry the standard 5/8" (i will assume thats what you have). Race shops like Summit carry them. Automotive parts houses and tractor supply, farm and fleet may.
So 5/8 is the steering shaft OD? Or is it a 5/8 u-joint? Thanks 
|
|
| Author: | hillaholic [ Fri Apr 18, 2008 9:12 am ] |
| Post subject: | |
I just measured a new shaft I have and the OD is 0.875" and the ID is 0.665 |
|
| Author: | Odyknuck [ Fri Apr 18, 2008 9:44 am ] |
| Post subject: | |
I stand corrected. I did a little research and the 5/8" is typically a splined weld on shaft. Steering shafts are avalable in 3/4" and 7/8". My new buggy is using 3/4" shafts with and with out splines. |
|
| Author: | Bad Influence [ Fri Apr 18, 2008 10:15 am ] |
| Post subject: | |
Thanks!!! |
|
| Author: | GuyP [ Sat Apr 19, 2008 10:15 am ] |
| Post subject: | |
Don't know if this will help you, but here is where I bought mine. http://www.speedwaymotors.com/p/2031,17 ... oints.html They had more than they list on their site. |
|
| Page 1 of 1 | All times are UTC - 5 hours [ DST ] |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|