WoodsBuggy.com
http://www.woodsbuggy.com/phpBB3/

Extended front arm pics?
http://www.woodsbuggy.com/phpBB3/viewtopic.php?f=4&t=2174		 Page 1 of 1
Author:  59bisquik [ Fri Dec 07, 2007 4:07 am ]
Post subject:  Extended front arm pics?
After reading lots of posts, I have a question. Does anybody have pics of thier extended front arms and the jig they used?

Mad Mikes are really nice...just curious what a jig would look like. I dont want to reinvent the wheel...since many have already done it.

I am normally on www.thesamba.com...but they flame anybody that wants to make thier own arms and such!

Thanks in advance guys!
Author:  Firebug [ Fri Dec 07, 2007 4:04 pm ]
Post subject: 
Here is my bus beam with longer arms

Image
Author:  59bisquik [ Fri Dec 07, 2007 4:15 pm ]
Post subject: 
wow! those look pretty long! Do you have a bigger picture? How much travel are you getting?

I am installing the big towers and running Fox 10" resevoirs. I am shooting for 12" of travel. My car is not a woods buggy, it spends most of its time out in the desert in really rough terrain.
Author:  Firebug [ Fri Dec 07, 2007 4:34 pm ]
Post subject: 
I took that pic with my phone,,here are some a little bigger.

Image



Here is my jig

Image
Author:  Firebug [ Fri Dec 07, 2007 4:46 pm ]
Post subject: 
Here is a bigger pic,,,the travel is about 12 inches... not as much a lot of kingpin fronts but it stays tighter from my experiences.

Image
Author:  59bisquik [ Fri Dec 07, 2007 4:50 pm ]
Post subject: 
Wow! Thats nice! :D

How much longer than stock are they?!
Author:  Firebug [ Fri Dec 07, 2007 6:58 pm ]
Post subject: 
They measure 3 inches longer or 12 versus 9. When I built this I borrowed most of the ideas from Blindchickenracing, but they use kp and I use bj. I built it when I was mostly trail riding. Now that I am trying to climb hills I find that this setup is much heavier than most of the guys on this site. Oh well , I still like it and the extra weight helps off set that heavyass wc engine. :wink:
Author:  59bisquik [ Fri Dec 07, 2007 9:10 pm ]
Post subject: 
Mine is a Chenowth car wit a 6" wider beam...it is very heavy. I doubt the extended arms will add that much weight! :) Thanks!
Author:  RaceBugg1098 [ Mon Dec 10, 2007 9:39 am ]
Post subject: 
i just picked up a new set of woods 4" over arms. they look pretty tough. i bet they are as nice as the foddrills.
Page 1 of 1 All times are UTC - 5 hours [ DST ]
Powered by phpBB® Forum Software © phpBB Group
https://www.phpbb.com/