| WoodsBuggy.com http://www.woodsbuggy.com/phpBB3/ |
|
| IRS pivots http://www.woodsbuggy.com/phpBB3/viewtopic.php?f=4&t=17822 |
Page 1 of 1 |
| Author: | Psycho Alpha [ Mon Jun 22, 2015 7:20 pm ] |
| Post subject: | IRS pivots |
How do you guys weld in your irs pivots? With frame level and Using the jig pivots are at 3* On my current frame I could Not use a jig and I set them at 7*. Not sure if I should go stock or not?????? I like how susp is setup on current buggy,7* should give my more + caber than 3*? Thanks for any input |
|
| Page 1 of 1 | All times are UTC - 5 hours [ DST ] |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|