Has anyone ever successfully ran 4 lug balljoint rotors on Wright Place sindles?? I ordered bearings, but I don't think they are right for what I am thinking, and I cant seem to find a seal...

Screw it, I talked to McKenzie's because I heard they had a lot of knowledge of these older spindles, he pretty much told me that he didn't think it was possible to run the 4 lug rotors on them, which confirms me not being able to find bearings and seals to convert it over with... Plus I don't want to modify my rotors etc incase I break one in the woods and ruine my whole weekend. Soooo, hate to do it, but probably going to cut the spuds off and weld on balljoint spuds!

Jeff, are you having it done by a pro? I hope so because your putting your life on the line.

_________________
Water cooled Dry Sumped Subaru Powered Turbo Charged Fuel Injected 2500CC Tank. Oh Rah! He who dies with the most Toys not only wins, He also wears them out!

i run balljoint spindals on a link pin beam . just drill them and bolt them on. grind the frount bolt or it wont turn very sharp .i have never had a problem out of mine yet

_________________
get you some

I can weld pretty damn good Steve, better than 90% of our mechanics at work ... Thanks for the concern though

These are a Porsche stub, they can be converted to run kinpin hubs, but I can't find the correct bearings or seals to run the balljoint hubs. I will just burn in the ball joint spuds.

Jeff i run the spuds from the king kong combo spindles. You can get them from dans performance. I dont know if they have a bearing conversion to go with a 4 lug hub though. You can call dan or call tweed and ask them. I know the spuds I run are huge and will never bend.