I just purchased a custom housing and would like to know what the degree it is suppose to be

i set mine at +3. but im no expert buggy builder.

that is what I heard but wanted to verify it before I burn it in.

built 3 like that myself and it seems to work good!

_________________
lets just ride

where do i measure this on a stock torsion? and how thick of material should i use to cap the back of the frame horns?

_________________
If it ain't broke ill fix that

Put your degree finder on the flat spot on the end right above were your torsion bars go in. You should see a threaded hole there. Just me but i havent had any luck offsetting the torsion, doesnt make any sense to me but i went back to setting them to 0 and notching the spring plates.