WoodsBuggy.com
http://www.woodsbuggy.com/phpBB3/

Kingpin front end set-ups.. arms spindles..
http://www.woodsbuggy.com/phpBB3/viewtopic.php?f=4&t=12080		 Page 1 of 1
Author:  JeffClay [ Tue Jul 26, 2011 2:55 am ]
Post subject:  Kingpin front end set-ups.. arms spindles..
I'm thinking about starting to gather parts to convert my buggy over to a kingpin front end. I drove willies buggy with the longer arms and whatnot, and it drove really nice, soaked up all the bumps, etc. Of course, I didn't think anything of it then and didn't really look at anyone's setup.. If you guys could post some pictures I would appreciate it. Is everyone running beam adjusters, or just twisting them and the longer arms? What about the spindles, balljoint spuds? Don't kingpin spindles have smaller tie rod end holes? Thanks in advance.
Author:  mudd mutt [ Thu Jul 28, 2011 2:04 am ]
Post subject:  Re: Kingpin front end set-ups.. arms spindles..
Jeff give me a call this weekend,I have a couple sets of the old "WrightPlace" hd spindles I'm thinking bout sell in,I got combos now but I dont know why I never had a prob with the hd's :roll:
Author:  JeffClay [ Thu Jul 28, 2011 2:18 am ]
Post subject:  Re: Kingpin front end set-ups.. arms spindles..
do the wright place work with balljoint beam, or do I have to still put the kingpin beam in?
Author:  woogiebugger1 [ Thu Jul 28, 2011 11:33 am ]
Post subject:  Re: Kingpin front end set-ups.. arms spindles..
BugZyla.com has arms to convert BJ to LP without changing the beam. 2.5 X 1 = 369.00 . Others are also available. Check them out.
Author:  JeffClay [ Fri Jul 29, 2011 8:05 am ]
Post subject:  Re: Kingpin front end set-ups.. arms spindles..
yeah, i'm thinking more along the lines of cutting up stock arms and making them, a lot cheaper, plusssssssssssssss, i want to keep stock shock mounting location, because I don't want big, ugly shock towers on my frame...
Page 1 of 1 All times are UTC - 5 hours [ DST ]
Powered by phpBB® Forum Software © phpBB Group
https://www.phpbb.com/