| WoodsBuggy.com http://www.woodsbuggy.com/phpBB3/ |
|
| bearings for a bj beam http://www.woodsbuggy.com/phpBB3/viewtopic.php?f=4&t=11367 |
Page 1 of 1 |
| Author: | muff [ Wed Mar 02, 2011 7:42 pm ] |
| Post subject: | bearings for a bj beam |
does anyone happen to have a part number for the bearing inside a ball joint front end? or know where to get them? thanks |
|
| Author: | MadMike [ Wed Mar 02, 2011 8:21 pm ] |
| Post subject: | Re: bearings for a bj beam |
Most drive the bearings out and replace them with some sort of plastic, polyurethane or delrin. Any of our parts sponsors can help with that. |
|
| Author: | diamonddav [ Wed Mar 02, 2011 9:26 pm ] |
| Post subject: | Re: bearings for a bj beam |
where u at in ohio? you could get them from drews off road in hamilton, i used the red polyurethane ones on mine they work ok but ive read other people talk about a different brand that were a different color that were better a better fit cause its pretty hard to get the arms back into the red ones, some say you can grind out the inside of the red ones a bit to fit easier but i just used grease and a big ass hammer!! and if you dont have the zirk grease fittings on your beam , while you have the arms out replacing the "bearings" pack the beam full of grease with a grease gun! hope this helps |
|
| Author: | smitty [ Thu Mar 03, 2011 8:55 am ] |
| Post subject: | Re: bearings for a bj beam |
try the ones from bug pack. I have had better luck with them, they are harder than other brands i have tried . |
|
| Author: | muff [ Fri Mar 04, 2011 7:15 pm ] |
| Post subject: | Re: bearings for a bj beam |
thanks for the replies, but im trying to stay with the roller bearings instead of plastic bushings. i think i have it taken care of thanks |
|
| Page 1 of 1 | All times are UTC - 5 hours [ DST ] |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|