What size allthread do you all use for through rod? I have an idea to use it but I will use the set screw to hold a threaded tube inside the arm ,thus letting the allthread allow the arms to move in suspension and hold the arms to the buggy. input please

_________________
If your clutch ain't slippin,, you probably got it adjusted right!!!!!

1 inch.

Or at least that is what they used to ancor the uprights on my building. Or was you talking about buggys?

Mine are a piece of 3/4" soild round cut to fit into the main pivots. Then I drilled and tapped 1/2"-13 thread into the ends and put in long set screws bottemed into the end of the thread with locktight. Instead of nuts I used threaded lock collers with brass washers.

_________________
Of all the things I've lost, I miss my mind the most.
M
A
G
A

i used half inch threaded rod, on the ends, i used threaded locking shaft collars, and a tefflon washer. and then i had to drill a hole at the end of the rod and put a cotter pin to keep the shaft collar from turning.
dave

this what you used?

or would this be better?