| WoodsBuggy.com http://www.woodsbuggy.com/phpBB3/ |
|
| used engine parts???? http://www.woodsbuggy.com/phpBB3/viewtopic.php?f=3&t=8872 |
Page 1 of 1 |
| Author: | vw_brandon [ Sun Feb 28, 2010 4:53 am ] |
| Post subject: | used engine parts???? |
anybody know where i can find some used engine parts? to make at LEAST a 1915 for this year? dont wanna have to run a stock motor this year but i dont wanna spend alot on new parts to make a 1915 cause i wanna go bigger than a 1915 next year |
|
| Author: | gasman [ Sun Feb 28, 2010 10:09 am ] |
| Post subject: | Re: used engine parts???? |
so are you just looking for a used a used set of 94's.if you have a good bottom end then thats all you would need and put new rod bearings in it and new mains since you got it down to have cut.probly one of our sponsors would have a good used set or wait til the swap meet at drews if you dont find a set before then.chad 
|
|
| Author: | vw_brandon [ Sun Feb 28, 2010 10:46 pm ] |
| Post subject: | Re: used engine parts???? |
so your sayin all i need is a set of 94 piston and cylinders, dont i have to change the cam? |
|
| Author: | kybuggy1 [ Mon Mar 01, 2010 1:31 am ] |
| Post subject: | Re: used engine parts???? |
It will run with the cam thats in it, but a cam change can make a huge difference in power. |
|
| Author: | vw_brandon [ Mon Mar 01, 2010 4:53 am ] |
| Post subject: | Re: used engine parts???? |
kybuggy1 wrote: It will run with the cam thats in it, but a cam change can make a huge difference in power. whats a good cam? ive herd of a good v somethin other kind |
|
| Author: | dunebuggynut [ Mon Mar 01, 2010 10:24 am ] |
| Post subject: | Re: used engine parts???? |
You will need to cut the block for 94's & Ive never seen a stock case that didnt need line bored. Your heads will need cut too & you may as well raise the compression a bit. Its free HP. Put a windage tray in it if you arent going dry sump. Id put a 110 cam in it & you can put 1.25 rockers on it to gain HP. You can get a solid bottom end together for about 750 bucks using new P&C's. It will probably pump out about 75 HP with the right stuff in it. |
|
| Author: | Dave Winterburn [ Tue Mar 02, 2010 3:24 am ] |
| Post subject: | Re: used engine parts???? |
My slant on used parts, are that they're from (preferably)1970's engines. Used and abused. I know that VW (Mexican beetle) only quit building? What 6 -8 years ago? But what was commonly imported due to emision control, is pretty old. So used parts, especially if they are from different engines, (with varying amounts of wear) would have to be a very causious build. Blue print all the components and ballance them. |
|
| Page 1 of 1 | All times are UTC - 5 hours [ DST ] |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|