| WoodsBuggy.com http://www.woodsbuggy.com/phpBB3/ |
|
| 1.7 bus crank offset grind http://www.woodsbuggy.com/phpBB3/viewtopic.php?f=3&t=8079 |
Page 1 of 1 |
| Author: | FOX SHOX [ Sun Nov 15, 2009 9:10 pm ] |
| Post subject: | 1.7 bus crank offset grind |
Well, if I want to offset grind the stock crank that I have, could I weld( with a regular welder) the outside of the journals and then go to the machine shop and regrind the crank to stock rods?? The price of a 74mm crank is a little to high for me(I'm cheap) so could this be or am I way off base?? Thanks Dave ( doing an upright conversion)T |
|
| Author: | hyde [ Sun Nov 15, 2009 9:36 pm ] |
| Post subject: | Re: 1.7 bus crank offset grind |
Most shops like to grind to a smaller journal . But some will weld & grind . I dont no of a shop that will grind after some body welds by hand They have a machine |
|
| Author: | FOX SHOX [ Mon Nov 16, 2009 6:43 am ] |
| Post subject: | Re: 1.7 bus crank offset grind |
Thanks, I'll check around and see. Didn't know if that was how it was done or not. Thanks Dave T |
|
| Page 1 of 1 | All times are UTC - 5 hours [ DST ] |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|