It is currently Sun May 03, 2026 4:06 am

View unanswered posts | View active topics


Board index » Tech and Fab » Air Cooled Engines

All times are UTC - 5 hours [ DST ]



Post new topic Reply to topic  Page 1 of 1
  [ 2 posts ] 
  Print view Previous topic | Next topic 
Author Message
quarter
 Post subject: engine bolts?
PostPosted: Thu Mar 26, 2009 10:47 pm 
Offline

Joined: Wed Nov 14, 2007 11:11 pm
Posts: 4
Location: Lucasville, Ohio
I was wondering if anyone could tell me what size bolts are used in bolting the two lower engine bolts to the transmission? These are the two that are threaded into the block. I was wondering what size bolt and the threads. Thanks Roy
Top
 Profile  
 
turboblue
 Post subject: Re: engine bolts?
PostPosted: Fri Mar 27, 2009 9:48 am 
Offline
WoodsBuggy Addict
User avatar

Joined: Mon Feb 19, 2007 2:23 pm
Posts: 2039
Location: Central Indiana
quarter wrote:
I was wondering if anyone could tell me what size bolts are used in bolting the two lower engine bolts to the transmission? These are the two that are threaded into the block. I was wondering what size bolt and the threads. Thanks Roy


10mm x 1.5 thread pitch x about 80mm long.
Needs to be a stud rather than a bolt too.
Longer if you have a bus transmission.

_________________
Gary

Turbo VW Sand Racer
Polaris Ranger



"If you don't run into the Devil every once in awhile, you must be going in the same direction!"

Davis Motorsports FaceBook Page
Top
 Profile  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  Page 1 of 1
  [ 2 posts ] 

Board index » Tech and Fab » Air Cooled Engines

All times are UTC - 5 hours [ DST ]

Who is online

Users browsing this forum: No registered users and 1 guest

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Search for:
Jump to:  
Powered by phpBB® Forum Software © phpBB Group