| WoodsBuggy.com http://www.woodsbuggy.com/phpBB3/ |
|
| 1915 question http://www.woodsbuggy.com/phpBB3/viewtopic.php?f=3&t=4753 |
Page 1 of 1 |
| Author: | sv1332 [ Thu Sep 25, 2008 10:41 pm ] |
| Post subject: | 1915 question |
what is a good cam, heads and rocker setup for 1915? |
|
| Author: | DVS1 [ Thu Sep 25, 2008 11:19 pm ] |
| Post subject: | Re: 1915 question |
Most woods riders and hill climbers use a Engle W-110 or something similar for the cam and 1.25 rockers. As for heads I think a set of CB 044's usually work very well. |
|
| Author: | turboblue [ Fri Sep 26, 2008 11:27 am ] |
| Post subject: | Re: 1915 question |
DVS1 wrote: Most woods riders and hill climbers use a Engle W-110 or something similar for the cam and 1.25 rockers. As for heads I think a set of CB 044's usually work very well. Ditto Single 40/44 IDF properly tuned, TriMill exhaust, 9-9.5 compression and that little engine will rock....... 
|
|
| Author: | Roy [ Mon Sep 29, 2008 7:51 am ] |
| Post subject: | Re: 1915 question |
Another great camshaft for a 1915 is the VZ-15. This works great if you want to use the stock rocker arms. Very good all around camshaft and you don't have to spend the money on rocker arms. |
|
| Author: | sv1332 [ Wed Oct 01, 2008 3:13 pm ] |
| Post subject: | Re: 1915 question |
What is a good rocker arm manufacuter? Afforbality wise and quality wise? |
|
| Author: | turboblue [ Wed Oct 01, 2008 3:41 pm ] |
| Post subject: | Re: 1915 question |
sv1332 wrote: What is a good rocker arm manufacuter? Afforbality wise and quality wise? CB Performance is tough to beat. |
|
| Author: | sv1332 [ Wed Oct 01, 2008 4:02 pm ] |
| Post subject: | Re: 1915 question |
As for the heads what intake and exhaust port size? Would 40mm Intake X 35.5mm Exhaust be a good head to run wtih this setup? |
|
| Author: | chris38375 [ Wed Oct 01, 2008 5:11 pm ] |
| Post subject: | Re: 1915 question |
i have a set of 1.25 autocraft rockers i will sell ya,mofoco makes a really good head to |
|
| Author: | DVS1 [ Wed Oct 01, 2008 5:26 pm ] |
| Post subject: | Re: 1915 question |
sv1332 wrote: As for the heads what intake and exhaust port size? Would 40mm Intake X 35.5mm Exhaust be a good head to run wtih this setup? Those valves will work well for a lower RPM motor like in the woods. Especially with chamber work and a good port and polish. If your looking for a high RPM street screamer then go with a 44x37.5 valved head. |
|
| Page 1 of 1 | All times are UTC - 5 hours [ DST ] |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|