| WoodsBuggy.com http://www.woodsbuggy.com/phpBB3/ |
|
| removal of the crankcase pulley? http://www.woodsbuggy.com/phpBB3/viewtopic.php?f=3&t=454 |
Page 1 of 1 |
| Author: | 67fastback [ Sat May 12, 2007 7:06 pm ] |
| Post subject: | removal of the crankcase pulley? |
Ok how can I get this pulley off? any tricks or tools I need to pull it? Anything special I need to know? |
|
| Author: | will_545 [ Sun May 13, 2007 2:49 am ] |
| Post subject: | |
I am in the same boat. But i have to change that and the rear main seal. My motor is out and on the ground. My friend told me to bolt a 4 foot C iron to the fly wheel and then take the rear main nut off. While i have it like that i am going to get the change the other because it has a crack in it. |
|
| Author: | Roy [ Sun May 13, 2007 4:58 am ] |
| Post subject: | |
Pulling off the pulley works best if you have the puller designed for doing this. Sometimes they get stuck on there pretty good. If you can't find a puller, a last resort would be two pry bars, one on each side. Get a buddy to tap the backside of the pulley easy while you apply easy pressure with the prybars. Roy |
|
| Page 1 of 1 | All times are UTC - 5 hours [ DST ] |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|