| WoodsBuggy.com http://www.woodsbuggy.com/phpBB3/ |
|
| 009 Question http://www.woodsbuggy.com/phpBB3/viewtopic.php?f=3&t=4015 |
Page 1 of 1 |
| Author: | FlaBaja [ Tue Jun 10, 2008 11:55 pm ] |
| Post subject: | 009 Question |
I have an old 009 that I was planning on using. I finally got around to messing with it and the shaft doesnt seem to spin very freely. I can get it to rotate by hand but its pretty stiff. Does anyone know of a good way to fix this or should I just spring for a new one? |
|
| Author: | rockrockets1 [ Wed Jun 11, 2008 7:55 am ] |
| Post subject: | Re: 009 Question |
|
|
|
| Author: | turboblue [ Wed Jun 11, 2008 12:12 pm ] |
| Post subject: | Re: 009 Question |
Is it a German version Jim? Look on teh bottom. I would rather have a German version you need to repair as a new one that will probably cost well over a $150 now. Lots of knock offs out there too but beware of those. Last one I checked had 28° of advance in it. Springs and advance plates looked like a 9 year old made them, probably did actually......... 
|
|
| Page 1 of 1 | All times are UTC - 5 hours [ DST ] |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|