I have an old 009 that I was planning on using. I finally got around to messing with it and the shaft doesnt seem to spin very freely. I can get it to rotate by hand but its pretty stiff. Does anyone know of a good way to fix this or should I just spring for a new one?

_________________
Jim

Is it a German version Jim?
Look on teh bottom.

I would rather have a German version you need to repair as a new one that will probably cost well over a $150 now.
Lots of knock offs out there too but beware of those.
Last one I checked had 28° of advance in it.
Springs and advance plates looked like a 9 year old made them, probably did actually.........

_________________
Gary

Turbo VW Sand Racer
Polaris Ranger



"If you don't run into the Devil every once in awhile, you must be going in the same direction!"

Davis Motorsports FaceBook Page