Hey all,
New member, just goy a homemade rail, will post some pics of it later. Question I have, what engine is it...AE 527393, and how do I tell what tranny I have. Also, was adjusting the valves (previous owner said they needed to be checked) dropped the right valve cover, it was dry, dropped the left side and it puked, oil with some water mixed in. Why dry on one side and wet on the other? Sorry so long, thanks for any and all help.

[quote='wamullins']Hey all,
New member, just goy a homemade rail, will post some pics of it later. Question I have, what engine is it...AE 527393, and how do I tell what tranny I have. Also, was adjusting the valves (previous owner said they needed to be checked) dropped the right valve cover, it was dry, dropped the left side and it puked, oil with some water mixed in. Why dry on one side and wet on the other? Sorry so long, thanks for any and all help.[/quote]

Welcome new

Welcome to the site

Thanks for the help and the welcome. I will probably have a lot more questions. Where can I find a wiring diagram, I think this one has the generator on it. Once again, Thanks

where abouts in ne alabama?

_________________
If your clutch ain't slippin,, you probably got it adjusted right!!!!!

Welcome to the site. Send me your email address and I will send you the diagrams that I have for generator and alternator set ups and a few other options.

The WIld Kids

_________________
I refuse to grow up therefore I will never grow old, and I will never die.

located in the very NE corner on Sand Mtn, where AL, TN, and GA meet. I could walk in a 5 mile circle and go thru 3 states.

Do you have any good riding places in your area?

_________________
If your clutch ain't slippin,, you probably got it adjusted right!!!!!

not for sure, I've been out of off-roading for about 10 yrs, used to do some 4 wheeling on Aetna, have several old coal mines around