WoodsBuggy.com http://www.woodsbuggy.com/phpBB3/
THROW OUT BEARING ROD http://www.woodsbuggy.com/phpBB3/viewtopic.php?f=3&t=17917	Page 1 of 1

---

Author:	gregmartin [ Mon Oct 19, 2015 2:37 pm ]
Post subject:	THROW OUT BEARING ROD
It seems my new Throw Out Bearing won't fit on my Bearing Rod. My research tells me it won't. My question is it looks pretty easy to modify it. Does any one know if common practice to do it or should I just buy a new one. I can certainly do the modification is its been done before. Sent from my iPad using Tapatalk Attachments: ImageUploadedByTapatalk1445279874.395968.jpg [ 95.89 KiB | Viewed 3054 times ] ImageUploadedByTapatalk1445279859.328480.jpg [ 99.41 KiB | Viewed 3054 times ] ImageUploadedByTapatalk1445279836.962253.jpg [ 102.63 KiB | Viewed 3054 times ]

---

Author:	Roy [ Sun Oct 25, 2015 9:01 am ]
Post subject:	Re: THROW OUT BEARING ROD
You have a mis-match of parts. The throw out bearing you show is designed to run without the guide sleeve installed in your bellhousing. You can switch to the later throwout shaft designed for the later bearing that runs on this sleeve. This design is way better.

---

Author:	gregmartin [ Sun Oct 25, 2015 11:21 am ]
Post subject:	Re: THROW OUT BEARING ROD
Thanks Roy, I have a new one on the way. Sent from my iPad using Tapatalk

---

Page 1 of 1	All times are UTC - 5 hours [ DST ]
Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/