Joined: Mon Dec 10, 2012 8:01 pm Posts: 6
|
so i was runnin like crap did a tune up plugs wires filters ect... then a compression check cylinder #1=130psi #2=120psi #3=60psi #4=65 psi so i retourqed the head on driver side then my valves were out of adjustment i couldnt get my adjusters loose enough ran out so checked the compression again with valves out of wack got #3=155psi #4=180 how is this possible idk so then tore hole top of motor down put new rings in and put it back togeather decided to just put a spacer behind my rockers to get valves in adjustment then tested compression and got #1=110#2=100#=90#4=70 so just lookin for answer have not ran motor with new rings maybe they need to seat in idk open to suggestions o also checked my barrel shims and head shims both spec out good so idk
Last edited by Kenney on Wed Jun 05, 2013 2:06 pm, edited 1 time in total.
|
|