Cima/Mahle all the way here too.
Just in your spare time, try reading this:
http://www.thesamba.com/vw/forum/viewtopic.php?t=247742
Remember most of this is about their racing piston kits but...........
| WoodsBuggy.com http://www.woodsbuggy.com/phpBB3/ |
|
| Piston and Cylinder kits feedback. http://www.woodsbuggy.com/phpBB3/viewtopic.php?f=3&t=1513 |
Page 1 of 1 |
| Author: | A. Cole [ Wed Oct 17, 2007 5:14 pm ] |
| Post subject: | Piston and Cylinder kits feedback. |
I'm looking into new piston and cylinder kits and saw these AA-products for pretty cheap. http://www2.cip1.com/ProductDetails.asp?ProductCode=ACC%2DC10%2D5205&CartID=1 Just looking for some feedback. I know, as they say, you get what you pay for. Should I spend the extra fifty bucks for the cima/mahle http://www2.cip1.com/ProductDetails.asp?ProductCode=ACC%2DC10%2D5169 |
|
| Author: | KFondren [ Wed Oct 17, 2007 9:12 pm ] |
| Post subject: | forged without a doubt |
I would go with the forged cima or mahle kit. Ive used them in several motors ive built and never had any problems. Cast pistons wont handle the heat as well. |
|
| Author: | DVS1 [ Wed Oct 17, 2007 11:16 pm ] |
| Post subject: | |
I have used two of the AA kits and both only lasted one season. The Cima/Mahle is definitly the better choice of the two. |
|
| Author: | turboblue [ Thu Oct 18, 2007 12:12 pm ] |
| Post subject: | |
Cima/Mahle all the way here too. Just in your spare time, try reading this: http://www.thesamba.com/vw/forum/viewtopic.php?t=247742 Remember most of this is about their racing piston kits but...........
|
|
| Page 1 of 1 | All times are UTC - 5 hours [ DST ] |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|