There are a few guys that were asking me about power steering pulleys. I use the one from competition engineering,
http://cevw.com/products.php
It's a real nice one piece pulley, but it is a little pricey. About $125. There is also the one from saco performance,
http://www.sacoperformance.com/proddeta ... od=64-4150
which is $29 and easy to install. all you do is put it up to your main pulley and drill 3/16 hole about 1/8 inch deep that a roll pin fits into. Then you use a longer crank shaft bolt to hold it together.

Roll pin goes in the keyway holeon scat one. and we just ordered from cevw.com and its 180.00 total with the bolt.

its been a couple years since i bought the one from cevw ok now matt has a small hole in his pulley .he got it used with no instructions