| WoodsBuggy.com http://www.woodsbuggy.com/phpBB3/ |
|
| Anyone sell just the 4 head studs for sp to dp conv http://www.woodsbuggy.com/phpBB3/viewtopic.php?f=3&t=14131 |
Page 1 of 1 |
| Author: | BradHall [ Wed Sep 26, 2012 8:10 am ] |
| Post subject: | Anyone sell just the 4 head studs for sp to dp conv |
Do any of you know anywhere that sells just the 4 center head studs to go from a single port to dp heads. |
|
| Author: | BradHall [ Wed Sep 26, 2012 8:37 am ] |
| Post subject: | Re: Anyone sell just the 4 head studs for sp to dp conv |
Also thought about just making some spacers if this wouldn't cause a problem later since some of these studs have been really hard to get out. |
|
| Author: | Aaron Creech [ Wed Sep 26, 2012 7:18 pm ] |
| Post subject: | Re: Anyone sell just the 4 head studs for sp to dp conv |
8mm or 10mm? You can't use spacers because the studs will hit the intakes,unless you are building a long stroke/long rod motor then you could use the longer studs. |
|
| Page 1 of 1 | All times are UTC - 5 hours [ DST ] |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|