| WoodsBuggy.com http://www.woodsbuggy.com/phpBB3/ |
|
| Milling a bellhousing for auto starter http://www.woodsbuggy.com/phpBB3/viewtopic.php?f=3&t=11935 |
Page 1 of 1 |
| Author: | vw2332 [ Tue Jun 28, 2011 7:20 pm ] |
| Post subject: | Milling a bellhousing for auto starter |
Need 2 know how much to mill off a 091 bellhousing so I can use a automatic starter. |
|
| Author: | MickeyMouse [ Tue Jun 28, 2011 7:48 pm ] |
| Post subject: | Re: Milling a bellhousing for auto starter |
Is the automatic the same as a 3rib? I might be crazy but I think it would be easier to change the bell housing of get a new starter.. |
|
| Author: | Firebug [ Tue Jun 28, 2011 8:07 pm ] |
| Post subject: | Re: Milling a bellhousing for auto starter |
the 091 has a beefier cross shaft,,,and 3 rib bells are getting harder to find,,,I think it is .250",,,Eric DeBord knows for sure. |
|
| Author: | bluebuggy [ Tue Jun 28, 2011 8:41 pm ] |
| Post subject: | Re: Milling a bellhousing for auto starter |
I was told .375 when I asked but never dont it so not sure |
|
| Page 1 of 1 | All times are UTC - 5 hours [ DST ] |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|