Thought some of you might need this.
http://midmoracing.com/bendit.htm
If you go here http://www.pirate4x4.com/tech/bendin_tube/index.html read the page and then you will know how to mark your die.

_________________
A good friend will bail you out of jail. A best friend will be sitting next to you saying: "Damn that was fun!"



http://www.youtube.com/watch?v=A5wGMaUMXUQ

That's cool. Thanks for sharing that.

John

Nice little program. Thanks for sharing!

Thanks, nice and simple just what i need.

_________________
Bye Bye Buggy, I'll always miss you and never forget you, your going to a better place now.

Thank's. Just tagged those sites 'caus I just got a model 3 as a early birthday- xmas gift. I'll be ordering a die set in the morning. Finally, I can get to the major frame reworking. Most everything else is ready to be bolted or welded on.

When first started twisting tubing I wished I had a program to assist me. But once I found this link and learned how to use it I forgot all about needing a bend program. All you need is a few tools which you should have already and a clean floor to work off of, which in my case I use a sheet of cardboard.
Look around their site have a lot of other good tech info.

http://www.pirate4x4.com/tech/bendin_tube/index.html

_________________
Roads.... Where we are going, we don't need roads!