WoodsBuggy.com http://www.woodsbuggy.com/phpBB3/ |
|
Custom torsion question http://www.woodsbuggy.com/phpBB3/viewtopic.php?f=26&t=17070 |
Page 1 of 1 |
Author: | NRIbuggys [ Thu Jun 12, 2014 8:23 am ] |
Post subject: | Custom torsion question |
What's the width need to be from outside to outside. Running the red poly bushings. Not measuring the outer caps. Sent from my iPhone using Tapatalk |
Author: | MadMike [ Thu Jun 12, 2014 3:11 pm ] |
Post subject: | Re: Custom torsion question |
If I had a stock torsion housing I would measure it for you. My Funco only has one VW part, the next one will have zero. |
Author: | NRIbuggys [ Thu Jun 12, 2014 4:05 pm ] |
Post subject: | Re: Custom torsion question |
The torsion was made on a jig for a stock torsion. But when we put the torsion bars in they try to shove the other out. We have the right spacers on the plates Sent from my iPhone using Tapatalk |
Author: | MadMike [ Thu Jun 12, 2014 4:19 pm ] |
Post subject: | Re: Custom torsion question |
What length bars and how much does it push out?? |
Author: | NRIbuggys [ Thu Jun 12, 2014 4:31 pm ] |
Post subject: | Re: Custom torsion question |
Stock bars and ab 1/2in on each side with them pushed in ab even Sent from my iPhone using Tapatalk |
Author: | NRIbuggys [ Thu Jun 12, 2014 4:32 pm ] |
Post subject: | Re: Custom torsion question |
Has ends on it like this Sent from my iPhone using Tapatalk |
Author: | NRIbuggys [ Thu Jun 12, 2014 6:22 pm ] |
Post subject: | Re: Custom torsion question |
Well mine is 40 1/2 and the one we having probs with is 39 1/2 Sent from my iPhone using Tapatalk |
Author: | NRIbuggys [ Thu Jun 12, 2014 6:24 pm ] |
Post subject: | Re: Custom torsion question |
Measuring from here side to side is 40 1/2 Sent from my iPhone using Tapatalk |
Page 1 of 1 | All times are UTC - 5 hours [ DST ] |
Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |