WoodsBuggy.com http://www.woodsbuggy.com/phpBB3/ |
|
Bending U bend header http://www.woodsbuggy.com/phpBB3/viewtopic.php?f=26&t=16924 |
Page 1 of 1 |
Author: | rip-it [ Tue May 06, 2014 7:37 am ] |
Post subject: | Bending U bend header |
How can I put a 90° bend to the right on this header after the down bend without destroy the finish? Is it possible? Any ideas? Sent from my DROID RAZR HD using Tapatalk |
Author: | rip-it [ Tue May 06, 2014 7:38 am ] |
Post subject: | Re: Bending U bend header |
Sent from my DROID RAZR HD using Tapatalk |
Author: | RaceBugg1098 [ Tue May 06, 2014 11:58 am ] |
Post subject: | Re: Bending U bend header |
if you buy the right shoe, and it doesnt kink, i bet it would sill scratch it up |
Author: | MadMike [ Tue May 06, 2014 1:03 pm ] |
Post subject: | Re: Bending U bend header |
Don't think there is enough tubing there to bend a 90 even if the finish wasn't important. |
Author: | RaceBugg1098 [ Wed May 07, 2014 7:32 am ] |
Post subject: | Re: Bending U bend header |
Author: | rip-it [ Wed May 07, 2014 9:27 am ] |
Post subject: | Re: Bending U bend header |
When I put it on the side like it should be it hits the frame. I will have to make the u-bend tighter. Then i probably could use one of those tips!! I also have a slip on super trap I want to be able to use when I go Road Dogging!! |
Page 1 of 1 | All times are UTC - 5 hours [ DST ] |
Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |